Configuration And Parameter Assignment - Siemens SIMATIC ET 200S Installation And Operating Manual

Configuring

2.4 Configuration and Parameter Assignment

2.4 Configuration and Parameter Assignment
2.4
Prerequisite
The following are required for configuring and assigning parameters for ET 200S fail-safe
modules:
•
•
•
The
http://www.siemens.com/automation/service&support
Configuring
Follow the usual procedure with
same way as standard ET 200S modules).
Parameter Assignment for Module Properties
To assign parameters for fail-safe module properties, select the module in
HW Config
Parameters are downloaded from the programming device to the F-CPU, where they are
stored and then transferred to the fail-safe module.
Parameter description
You will find a description of assignable fail-safe module parameters in this manual.
PROFIsafe Address and PROFIsafe Address Assignment
You can find a description of PROFIsafe addresses and the address assignment procedure
in this manual.
See also
Assignment of the PROFIsafe address (Page 3-3)
Parameters of the PM-E F pm DC24V PROFIsafe (Page 7-15)
Parameters of the PM-E F pp DC24V PROFIsafe (Page 7-31)
Parameters of the PM-D F DC24V PROFIsafe (Page 7-42)
Parameters of the EM 4/8 F-DI DC24V PROFIsafe (Page 7-51)
Parameters for the EM 4 F-DO DC24V/2A PROFIsafe (Page 7-88)
2-8
STEP 7
V5.1 SP 6 or higher (for PROFINET connection: STEP 7, V5.3 SP 3 or higher)
S7 Distributed Safety
V5.4 or higher (
S7 F Systems
, Version V5.2 SP 2 or higher
F Configuration Pack
and select the menu command "Edit > Object Properties".
F Configuration Pack
can be downloaded from the Internet from:
STEP 7 HW Config
Hardware Installation and Operating Manual, 07/2005, A5E00103686-04
V5.4 or higher)
to configure fail-safe modules (in the
ET 200S Distributed I/O System - Fail-Safe Modules
STEP 7