Siemens SIMATIC ET 200S Installation And Operating Manual page 81

Permissible potential difference between
•
•
•
Isolation in the series tested with
•
•
•
Isolation in the type test tested with
•
•
•
•
Current consumption
•
•
Power dissipation of the module
Status, Interrupts, Diagnostics
Status display
Diagnostic functions
•
•
Data for Selecting an Actuator for the Semiconductor Outputs**
Output voltage
•
Output current for "1" signal
•
•
For "0" signal (residual current)
Indirect control of load by means of interface
relay:
Residual current for "0" signal
•
•
Load resistance range
Lamp load
ET 200S Distributed I/O System - Fail-Safe Modules
Hardware Installation and Operating Manual, 07/2005, A5E00103686-04
Shield and ET 200S bus connection
Shield and I/O (DOs, P1/P2 buses)
ET 200S bus connection and I/O (DOs,
P1/P2 buses)
Shield and ET 200S bus connection
Shield and I/O (DOs, P1/P2 buses)
ET 200S bus connection and I/O (DOs,
P1/P2 buses)
Shield and ET 200S bus connection
Shield and I/O (DOs, P1/P2 buses)
ET 200S bus connection and I/O (DOs,
P1/P2 buses)
Impulse current test between ET 200S bus
connection and I/O (DOs, P1/P2 buses)
From backplane bus
From load voltage L+ (without load)
Group fault display
Diagnostic information can be displayed
For "1" signal
Rated value
Permissible range
P-Switch
M-Switch
7.2 PM-E F pm DC24V PROFIsafe Power Module
Technical Specifications
75 VDC/60 VAC
75 VDC/60 VAC
250 VAC
500 VDC/1 min or 600 VDC/1 s
500 VDC/1 min or 600 VDC/1 s
1500 VAC/1 min or 2545 VDC/1 s
350 VAC/1 min
350 VAC/1 min
2830 VAC/1 min
6000 VDC/5 positive and 5 negative pulses
28 mA, maximum
100 mA, typical
4 W, typical
Green LED per channel
•
Green LED for the load voltage
•
Red LED (SF)
Possible
Minimum L+ (-2.0 V)
•
P-switch: minimum L+ (-1.5 V), voltage drop in
•
M-switch: 0.5 V, maximum
2 A
20 mA to 2.4 A
0.5 mA, maximum
0.5 mA, maximum
4 mA, maximum
12 Ω to 1 kΩ
10 W, maximum
Fail-Safe Modules
7-21