Siemens SIMATIC ET 200S Installation And Operating Manual page 6

Preface
Guide
This manual describes the fail-safe modules of the ET 200S distributed I/O system. It
consists of instructive sections and reference sections (technical specifications and
appendices).
This manual presents the following basic aspects of fail-safe modules:
• Design and use
• Configuration and Parameter Assignment
• Addressing, assembly, and wiring
• Diagnostic assessment
• Technical Specifications
• Order numbers
Conventions
In this manual, the terms "safety engineering" and "fail-safe engineering" are used
synonymously. The same applies to the terms "fail-safe" and "F-."
S7 Distributed Safety
"
two F-systems: "S7 Distributed Safety" and "S7 F/FH Systems".
Recycling and Disposal
Due to the low levels of pollutants in the fail-safe modules of the ET 200S, the modules can
be recycled. For proper recycling and disposal of your old module (device), consult a
certified disposal facility for electronic scrap.
Additional Support
If you have any additional questions about the use of products presented in this manual,
contact your local Siemens representative:
http://www.siemens.com/automation/partner
Training center
We offer courses to help you get started with the S7 automation system. Contact your
regional training center or the central training center in Nuremberg (90327), Federal Republic
of Germany.
Telephone: +49 (911) 895–3200
Internet: http://www.sitrain.com
H/F Competence Center
The H/F Competence Center in Nuremberg offers special workshops on SIMATIC S7 fail-
safe and redundant automation systems. The H/F Competence Center can also provide
assistance with onsite configuration, commissioning, and troubleshooting.
Telephone: +49 (911) 895-4759
Fax: +49 (911) 895-5193
For questions about workshops, etc., contact: hf-cc@nbgm.siemens.com
vi
S7 F Systems
" and " " in italics refer to the optional packages for the
Hardware Installation and Operating Manual, 07/2005, A5E00103686-04
ET 200S Distributed I/O System - Fail-Safe Modules