Download  Print this page

Peripherals Settings; Peripherals Pairing Ciscotouchpanels Remotepairing; Peripherals Pairing Ultrasound Volume Maxlevel; Peripherals Pairing Ultrasound Volume Mode - Cisco TelePresence MX200 G2 Administrator's Manual

Hide thumbs

Advertisement

Cisco TelePresence MX200 G2 and MX300 G2
Introduction

Peripherals settings

Peripherals Pairing CiscoTouchPanels RemotePairing

In order to use Cisco Touch 10 (touch panel) as user interface for the video system, Touch
10 must be either directly connected to the video system or paired to the video system via
LAN. The latter is referred to as remote pairing.
Remote pairing is allowed by default; you must switch this setting Off if you want to prevent
remote pairing.
Requires user role: ADMIN
Default value: On
Value space: Off/On
Off: Remote pairing of Touch 10 is not allowed.
On: Remote pairing of Touch 10 is allowed.

Peripherals Pairing Ultrasound Volume Mode

This setting applies to the Intelligent Proximity feature. Keep the setting at its default value.
Requires user role: ADMIN
Default value: Dynamic
Value space: Dynamic/Static
Dynamic: The video system adjusts the ultrasound volume dynamically. The volume may
vary up to the maximum level as defined in the Peripherals Pairing Ultrasound Volume
MaxLevel setting.
Static: Use only if advised by Cisco.
D15332.01 MX200 G2 and MX300 G2 Administrator Guide CE8.0, NOVEMBER 2015.
Configuration
Peripherals
Maintenance

Peripherals Pairing Ultrasound Volume MaxLevel

This setting applies to the Intelligent Proximity feature. Set the maximum volume of the
ultrasound pairing message. Refer to the Peripherals Pairing Ultrasound Volume Mode
setting.
Requires user role: ADMIN
Default value: 70
Value space: Integer (0..90)
Select a value between 0 and 90. If set to 0, the ultrasound is switched off.

Peripherals Profile TouchPanels

Define the number of touch panels that are expected to be connected to the video system.
This information is used by the video system's diagnostics service. If the number of
connected touch panels does not match this setting, the diagnostics service will report it as
an inconsistency. Note that only one Cisco Touch controller is supported in this version.
Requires user role: ADMIN
Default value: Minimum1
Value space: NotSet/Minimum1/0/1/2/3/4/5
NotSet: No touch panel check is performed.
Minimum1: At least one touch panel should be connected to the video system.
0-5: Select the number of Touch controllers that are expected to be connected to the
video system.
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
91
Administrator Guide
System settings
System settings
Appendices

Advertisement

Table of Contents

   Related Manuals for Cisco TelePresence MX200 G2

This manual is also suitable for:

Telepresence mx300 g2

Comments to this Manuals

Symbols: 0
Latest comments: