Cisco TelePresence MX200 G2 Administrator's Manual page 33

Cisco TelePresence MX200 G2 and MX300 G2

Introduction
Set up Intelligent Proximity for content sharing
Enable the Proximity services
All Proximity services are disabled by default.
1. Sign in to the web interface, and navigate to
System Configuration.
Mode. Check that Proximity is On (default),
2. Go to Proximity >
so that the video system sends ultrasound pairing messages.
3. Enable the services you want to allow.
In order to fully utilise the Proximity functionality, we
recommend that you enable all services.
Place calls and control the video system:
• Go to Proximity > Services > CallControl
Enabled.
View shared content on a mobile device:
• Go to Proximity > Services > ContentShare > FromClients
and choose Enabled.
Wireless share from a mobile device:
• Go to Proximity > Services > ContentShare > ToClients
and choose Enabled.
D15332.01 MX200 G2 and MX300 G2 Administrator Guide CE8.0, NOVEMBER 2015.
Configuration Configuration Peripherals
Disable Proximity temporarily
You can temporarily disable Proximity in a meeting from the Touch
controller.
Configuration >
• Tap the contact information in the upper left corner of the
Touch controller, and switch Proximity on or off.
This is useful in meetings where you want to prevent devices in
the room from receiving content.
You cannot temporarily disable Proximity if using the TRC6 remote
control.
and choose
The Proximity indicator
The Proximity indicator is shown on both the main display
and the Touch controller.
Proximity is On, and at least one service is enabled.
The Proximity feature is temporarily disabled.
Maintenance
(page 3 of 4)
33
Administrator Guide
System settings
About Proximity
When Proximity is switched On, the
video system transmits ultrasound pairing
messages.
The Proximity feature is switched On by
default.
The ultrasound pairing messages are
received by nearby devices with Proximity
clients, and triggers the authentication
and authorization of the device.
For the best user experience, Cisco
recommends that Proximity always is
switched On .
*
In order to get full access to Proximity,
the Proximity services (Proximity >
Services > ...) must be Enabled as well.
* We recommend not to use a headset, if you have
switched on Proximity (ultrasound).
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
Appendices