Peripherals Settings; Peripherals Pairing Ultrasound Volume Maxlevel; Peripherals Pairing Ultrasound Volume Mode; Peripherals Profile Controlsystems - Cisco DX70 Administrator's Manual

Cisco DX70 and DX80

Introduction

Peripherals settings

Peripherals Pairing Ultrasound Volume Mode

This setting applies to the Intelligent Proximity feature. Keep the setting at its default value.
Requires user role: ADMIN
Default value: Dynamic
Value space: Dynamic/Static
Dynamic: The video system adjusts the ultrasound volume dynamically. The volume may
vary up to the maximum level as defined in the Peripherals Pairing Ultrasound Volume
MaxLevel setting.
Static: Use only if advised by Cisco.

Peripherals Pairing Ultrasound Volume MaxLevel

This setting applies to the Intelligent Proximity feature. Set the maximum volume of the
ultrasound pairing message. Refer to the Peripherals Pairing Ultrasound Volume Mode
setting.
Requires user role: ADMIN
Default value: DX80: 70 DX70: 60
Value space: DX80: Integer (0..90) DX70: Integer (0..60)
Select a value in the specified range. If set to 0, the ultrasound is switched off.
D15362.02 DX70 and DX80 Administrator Guide CE8.3, JANUARY 2017.
Configuration Peripherals Maintenance

Peripherals Profile ControlSystems

Define if a third-party control system, for example Crestron or AMX, is expected to be
connected to the video system. This information is used by the video system's diagnostics
service. If the number of connected control systems does not match this setting, the
diagnostics service will report it as an inconsistency. Note that only one third-party control
system is supported.
If set to 1, the control system must send heart beats to the video system using xCommand
Peripherals Pair and HeartBeat commands. Failing to do so will cause the in-room control
extensions to show a warning that the video system has lost connectivity to the control
system.
Requires user role: ADMIN
Default value: NotSet
Value space: 1/NotSet
1: One third-party control system should be connected to the video system.
NotSet: No check for a third-party control system is performed.
www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
86
Administrator Guide
System settings System settings Appendices