Serial Interface (Rs-232) - Cisco TelePresence MX200 G2 Administrator's Manual

Cisco TelePresence MX200 G2 and MX300 G2

Introduction

Serial interface (RS-232)

Use the micro USB connector for serial communication with
MX200 G2 and MX300 G2. You need a micro USB to USB cable,
and you may need to install a serial port driver on the computer.
The serial connection can be used without an IP-address, DNS, or
a network.
Parameters:
• Baud rate: 115200 bps
• Data bits: 8
• Parity: None
• Stop bit: 1
Video system settings
Serial communication is enabled by default. Use the following
configuration to change the behavior:
SerialPort > Mode
For security reasons, you are asked to sign in before using the
serial interface. Use the following setting to change the behavior:
SerialPort > LoginRequired
Restart the video system when you have made changes to the
serial port settings.
D15332.01 MX200 G2 and MX300 G2 Administrator Guide CE8.0, NOVEMBER 2015.
Configuration Peripherals
Computer
Micro USB connector
Maintenance
USB
USB to micro USB cable
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
135
Administrator Guide
System settings Appendices Appendices
Micro USB
Video
system
Remove the back
cover to get access to
the connectors.