Conference Farendcontrol Signalcapability; Conference Maxreceivecallrate; Conference Maxtotalreceivecallrate; Conference Maxtotaltransmitcallrate - Cisco TelePresence MX200 G2 Administrator's Manual

Cisco TelePresence MX200 G2 and MX300 G2

Introduction

Conference FarEndControl SignalCapability

Define the far end control (H.224) signal capability mode.
Requires user role: ADMIN
Default value: On
Value space: Off/On
Off: Disable the far end control signal capability.
On: Enable the far end control signal capability.

Conference MaxReceiveCallRate

Define the maximum receive bit rate to be used when placing or receiving calls.
Note that this is the maximum bit rate for each individual call; use the Conference
MaxTotalReceiveCallRate setting to set the aggregated maximum for all simultaneous active
calls.
Requires user role: ADMIN
Default value: 6000
Value space: Integer (64..6000)
Set the maximum receive call rate (kbps).

Conference MaxTransmitCallRate

Define the maximum transmit bit rate to be used when placing or receiving calls.
Note that this is the maximum bit rate for each individual call; use the Conference
MaxTotalTransmitCallRate setting to set the aggregated maximum for all simultaneous active
calls.
Requires user role: ADMIN
Default value: 6000
Value space: Integer (64..6000)
Set the maximum transmitt call rate (kbps).
D15332.01 MX200 G2 and MX300 G2 Administrator Guide CE8.0, NOVEMBER 2015.
Configuration Peripherals Maintenance

Conference MaxTotalReceiveCallRate

This configuration applies when using a video system's built-in MultiSite feature (optional) to
host a multipoint video conference.
Define the maximum overall receive bit rate allowed. The bit rate will be divided fairly among
all active calls at any time. This means that the individual calls will be up-speeded or down-
speeded as appropriate when someone leaves or enters a multipoint conference, or when a
call is put on hold (suspended) or resumed.
The maximum receive bit rate for each individual call is defined in the Conference
MaxReceiveCallRate setting.
Requires user role: ADMIN
Default value: 10000
Value space: Integer (64..10000)
Set the maximum receive call rate (kbps).

Conference MaxTotalTransmitCallRate

This configuration applies when using a video system's built-in MultiSite feature (optional) to
host a multipoint video conference.
Define the maximum overall transmit bit rate allowed. The bit rate will be divided fairly
among all active calls at any time. This means that the individual calls will be up-speeded or
down-speeded as appropriate when someone leaves or enters a multipoint conference, or
when a call is put on hold (suspended) or resumed.
The maximum transmit bit rate for each individual call is defined in the Conference
MaxTransmitCallRate setting.
Requires user role: ADMIN
Default value: 10000
Value space: Integer (64..10000)
Set the maximum transmit call rate (kbps).
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
71
Administrator Guide
System settings System settings Appendices