Cisco TelePresence MX200 G2 Administrator's Manual page 7

Cisco TelePresence MX200 G2 and MX300 G2

Introduction Introduction
Microphone LED behaviour
The LED behavior on microphones and Touch 10 has
changed. The microphone LED glows and the mute button
is active in the following scenarios:
• When initiating an outgoing call and until the call is
disconnected.
• When receiving an incoming call and until the call is
disconnected.
• When activating the VU meter on the web interface to
test the audio levels.
The color indications, green for active and red for muted,
have not changed.
Resolution changes
Collaboration Endpoint Software only supports displays
that support 16:9 resolution.
D15332.01 MX200 G2 and MX300 G2 Administrator Guide CE8.0, NOVEMBER 2015.
Configuration Peripherals
Remote monitoring
For increased security, it is only possible to take
snapshots of the local and far end video streams from the
video system's web interface, when a Remote Monitoring
option key is installed on the video system.
Remote monitoring is enabled once the option key is
added, and the video system is rebooted.
No warning messages or indicators are sent to the users
of the video system. Please provide adequate notice to
the users that the system administrator may monitor and
control the camera and screen.
Removed features
• MultiWay is no longer supported. CUCM ad hoc
conferencing or hosted conferences may be used
instead.
• Cisco CTMS is no longer supported. Other multipoint
conferencing solutions (involving Cisco TelePresence
Server, Cisco TelePresence MCU, and/or Cisco
TelePresence Conductor) may be used instead.
• MediaNet is no longer supported.
Maintenance
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
7
Administrator Guide
System settings Appendices