Place A Call Using The Web Interface - Cisco TelePresence MX200 G2 Administrator's Manual

Cisco TelePresence MX200 G2 and MX300 G2

Introduction

Place a call using the web interface

Sign in to the web interface and navigate to
Place a call
Even if the web interface is used to initiate the call, it is the
video system (display, microphones and loudspeakers)
that is used for the call; it is not the PC running the web
interface.
1. Navigate the Local, Directory or Recents lists to find the
correct entry; or enter one or more characters in the Search
or Dial field . Click the correct contact name.
*
2. Click Call in the contact card.
Alternatively, enter the complete URI or number in the Search and
Dial field. Then click the Call button that appears next to the URI
or number.
When searching, matching entries from the Local, Directory and Recents lists
*
will be listed as you type.
D15332.01 MX200 G2 and MX300 G2 Administrator Guide CE8.0, NOVEMBER 2015.
Configuration Peripherals
(page 1 of 2)
Call Control.
Maintenance
Show/hide call details
Click the information button to show details
about the call.
Click the button again to hide the information.
Hold and resume a call
Use the button next to a participant's name to
put that participant on hold.
To resume the call, use the button that is present
when a participant is on hold.
End a call
If you want to terminate a call or conference, click
Disconnect all. Confirm your choice in the dialog that
appears.
To disconnect just one participant in a conference, click
the button for that participant.
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
126
Administrator Guide
System settings Appendices Appendices