Voip Status; Line No; Phone Number; Network - Panasonic KX-UT670 Administrator's Manual

4.3.3.1 VoIP Status

Line No.

Description

Phone Number

Description
VoIP Status
Description
Value Range

4.4 Network

This section provides detailed descriptions about all the settings classified under the [Network] tab.

4.4.1 Basic Network Settings

This screen allows you to change basic network settings such as whether to use a DHCP server, and the IP
address of the unit.
Note
•
When you change the settings on this screen and click [Save], the message "Complete" is displayed,
and then the unit will restart automatically even if the unit is on a call.
•
Since the IP address of the unit will probably be changed if you change these settings, you will not be
able to continue using the Web user interface. To continue configuring the unit from the Web user
interface, log in to the Web user interface again after confirming the newly assigned IP address of the
Document Version 2011-11
Indicates the line number to which a phone number is assigned
(reference only).
Indicates the currently assigned phone numbers (reference only).
Note
•
The corresponding field is blank if a line has not yet been leased
or if the unit has not been configured.
Indicates the current VoIP status of each line (reference only).
•
Registered: The unit has been registered to the SIP server, and the
line can be used.
•
Registering: The unit is being registered to the SIP server, and the
line cannot be used.
•
Blank: The line has not been leased, the unit has not been
configured yet, or a SIP authentication failure has occurred.
Note
•
The status of the line may not be displayed immediately after
starting up the unit because the unit is still being registered to
the SIP server. To display the status, wait about 2 to 2.5
minutes, and then click [Refresh] to obtain updated status
information.
Section 4 Web User Interface Programming
Administrator Guide 55