Accessing The Web User Interface - Panasonic KX-UT670 Administrator's Manual

Account
Administrator Network
administrators,
etc.
Note
•
Only one account can be logged in to the Web user interface at a time. If you try to access the Web
user interface while someone is logged in, you will be denied access.
•
You cannot log in to the Web user interface even under the same account as someone who is already
logged in.
•
The user password is required to change the settings.
•
You can reset the account IDs and passwords to their factory default settings by performing Reset Web
ID/Password from the unit. For details, see 3.1.1 Reset Web ID/Password.

4.2.4 Accessing the Web User Interface

The unit can be configured from the Web user interface.
To access the Web user interface
1.
Open your Web browser, and then enter "http://" followed by the unit's IP address into the address field of
your browser.
Note
•
To determine the unit's IP address, perform the following operations on the unit:
1.
Press
2.
Tap [About phone] and then [Status].
3.
Confirm the IP address in [Network].
2.
For authentication, enter your ID (username) and password, and then click [OK].
Notice
•
When you log in as User to the Web user interface for the first time, the [Change User
Password] screen (® see 4.5.3 Change User Password) will be displayed. Enter a new
password, and then perform authentication again with the new password to log in to the Web user
interface.
Note
•
The default ID for the User account is "user", and the default password is blank. The ID cannot be
changed from the Web user interface, but it can be changed through configuration file
programming.
Document Version 2011-11
Target User
(default)
admin
on the Home screen, and then tap [Settings].
ID Password
(default)
adminpass
Section 4 Web User Interface Programming
Password Restrictions
•
When logged in as Administrator,
you can change the password for
both the User and Administrator
accounts (® see
4.5.2 Administrator
Password).
•
The password can consist of 6 to
16 ASCII characters
(case-sensitive) (® see
Entering Characters in
4.2.4 Accessing the Web User
Interface).
Administrator Guide 49