Setting The Director Offline; Configuring Director Identification - HP StorageWorks Director 2/140 Installation Manual

If the director is offline, the Set Online State dialog box appears, indicating the status is Offline.
4. Click Set Online.
A Warning dialog box appears, indicating status is online.
5. Click OK.
The Status table appears Online.

Setting the director offline

When the director is set offline, all ports are set offline. The director transmits the offline sequence
(OLS) to attached devices, and the devices cannot log in to the director. Use these steps to set the
director offline:
1. Notify the customer that the director is going offline.
1. Open HAFM.
The View All - HAFM 8.6 page appears.
2. Select the appropriate director icon.
The Hardware View page for the selected director appears.
3. Select Maintenance > Set Online State.
If the director is online, the Set Online State dialog box appears, indicating the status is Online.
4. Click Set Offline.
A Warning dialog box appears, indicating the director will be set offline.
5. Click OK.

Configuring director identification

Perform this procedure to configure the director name, description, location, and contact person for
HAFM. The information appears in multiple dialog boxes throughout the application. In addition,
the Name, Location, and Contact variables configured in the Configure Identification dialog box
correspond respectively to the SNMP variables sysName, sysLocation, and sysContact. These
variables are used by SNMP management workstations when obtaining data from managed
directors.
Follow these steps to configure the director identification:
1. At the Hardware View page, select Configure > Identification.
The Configure Identification dialog box appears
Figure 27 Configure Identification dialog box
2. Enter a director name of 24 or fewer alphanumeric characters in the Name box.
(Figure 27).
Director 2/140 installation guide 51