Set Date And Time Manually; Synchronize Date And Time - HP StorageWorks Director 2/140 Installation Manual

• Synchronize date and
Figure 25 Configure Date and Time dialog box

Set date and time manually

Use these steps to set the director date and time manually:
1. At the Configure Date and Time dialog box, select the Periodic Date/Time Synchronization box
to deselect the option (no check in the box).
The grayed-out Date and Time fields activate.
2. Click the Date boxes that require change, and enter numbers in the following ranges:
Month (MM): 1 through 12
Day (DD): 1 through 31
Year (YYYY): greater than 1980
3. Click the Time boxes that require change, and enter numbers in the following ranges:
Hour (HH): 0 through 23
Minute (MM): 0 through 59
Second (SS): 0 through 59
4. Click Activate to set the director date and time.

Synchronize date and time

Use these steps to set the director to periodically synchronize date and time with HAFM:
1. At the Configure Date and Time dialog box, select the Periodic Date/Time Synchronization box.
The Date and Time boxes are grayed-out and not selectable.
2. Click Activate to enable synchronization.
The director date and time synchronize with the HAFM date and time at the next update period
(at least once daily).
3. Click Sync Now to synchronize the director and HAFM immediately.
The Date and Time Synced dialog box appears.
Figure 26 Date and Time Synced dialog box
4. Click OK.
5. Click Activate to enable synchronization.
time, page 49
Director 2/140 installation guide 49