Verify Communication Between The Director And Hafm Appliance; Director Operational States And Symbols; Hardware View - HP StorageWorks Director 2/140 Installation Manual

6. If you want to generate a sequence of IP addresses, perform the following:
a. Select the Generate a sequence of IP addresses box.
b. Enter the last IP address in the Last IP box.
NOTE: All IP addresses in a sequence must be on the same subnet and have the same first three
octets.
7. Click OK.
Verify communication between the
Follow these steps to check director-to-server communication:
1. At the HAFM application main window (physical map or product list), inspect the shape and
color of the status symbol associated with the director icon.
Table 3

Director operational states and symbols

Operational state
Operational—Director-to-server communication has been established, the
director is operational, and no failures are indicated.
Degraded—Director-to-server communication has been established, but the
director is operating in degraded mode and requires service. This condition
is typical if a port or redundant FRU fails. Go to
Failed—Director-to-server communication has been established, but the
director failed and requires immediate service. Go to
Status Unknown—The director status is unknown because of a network
communication failure between the director and HAFM appliance. Go to
step 2.
2. Right-click the Director-140 icon. A pop-up menu for the selected director appears.
3. Check director status at the Hardware View page
steps:
• If the director is displayed as operational (no FRU alert symbols), go to "Configuring feature
key" on page 71.
• If director operation is displayed as degraded or a director failure is indicated (FRU alert
symbols and a yellow triangle or red diamond at the alert panel), refer to the HP
StorageWorks Director 2/140 service manual.
and HAFM appliance
director
step 2.
step 2.
(Figure 24), and complete one of the following
Table 3 explains these symbols.
Symbol
No status
symbol
Director 2/140 installation guide 47