Connecting The Director To A Power Source - HP StorageWorks Director 2/140 Installation Manual

1. Align a rear mounting bracket with the cage nuts you installed earlier, and the screw holes in the
rear mounting plate attached to the Director 2/140.
2. Attach a rear mounting bracket to a rear mounting plate by installing three (3) Phillips panhead
screws in the mounting plate holes. Do not tighten.
3. Adjust the position of the rear bracket so that the holes align with the cage nuts installed in the
cabinet rail.
4. Attach the rear mounting bracket to the cage nuts installed in the cabinet rail using three (3)
Phillips panhead screws. Tighten securely.
5. Tighten the screws attached to the rear mounting plate.
6. Repeat step 1

Connecting the director to a power source

The Director 2/140 includes two power supplies (labeled PS0 and PS1 on the rear of the unit) for
redundancy. Each power supply must be connected to an appropriate power source that provides
220-volt AC power.
The Director 2/140 is shipped with the following power cords:
• Two (2) PDU (power distribution unit) power cords
• Two (2) volt AC power cords
NOTE: The 110-volt AC power cords provided in the kit are not for use with the Director 2/140.
For more information, see the HP StorageWorks director power cord advisory.
WARNING!
the facility power receptacle is the correct type, supplies the required voltage, and is properly
grounded.
Connect each Director 2/140 power supply to a power distribution unit (PDU) receptacle using a
PDU power cord
38 Installing and configuring the director
through step 5 to attach a rear mounting bracket to the remaining rear rail.
To prevent electric shock, use only the supplied PDU power cord(s). Also, verify that
(Figure 13).