Installing The Shelf Brackets In The Rack; Installing The Shelf Brackets In Hp 9000, Hp 10000, And Hp 11000 Series Racks; Carton Contents For A Hp System/E Or Industry-Standard 19-In Rack Installation - HP StorageWorks Director 2/140 Installation Manual

2. Using a pallet jack, raise the pallet on which the director is mounted to the same height as the
top surface of the lift device.
3. Slide the director across from the pallet to the lift device.
Determine the appropriate rack-mount position. Remember that the director is 20 inches or 12U
4.
high.

Installing the shelf brackets in the rack

The procedure for installing shelf brackets varies depending on the type of rack. Select the
appropriate procedure for your rack type:
• "Installing the shelf brackets in HP 9000, HP 10000, and HP 11000 Series racks" on page 33.
• "Installing shelf brackets in an HP Rack system/e or 19-inch EIA rack" on page 35.

Installing the shelf brackets in HP 9000, HP 10000, and HP 11000 Series racks

Use these steps to install the two shelf brackets in an HP 9000, HP 10000, or HP 11000 Series
rack.
Determine the appropriate placement for the director inside the rack.
1.
NOTE: HP strongly recommends installing the Director 2/140 in the lowest position in the rack.
2. Along an exterior vertical rail of the rack cabinet, determine the position of the bottom of the
shelf bracket and count 1U up from this location.
3. Use a straight edge to locate the corresponding rack hole along the interior vertical rails of the
rack cabinet. Mark this location on each interior vertical rail.
4. Position a small angle bracket along the interior vertical rail
so that the two threaded holes on the small tab align with the 1U location marked in
Secure the angle bracket to the rail using two self-tapping sheet metal screws.
5.
(Figure 10). Align the angle bracket
Director 2/140 installation guide
step 3.
33