GE T60 Instruction Manual page 177

5 SETTINGS
The GSSE/GOOSE configuration main menu is divided into two areas: transmission and reception.

PATH: SETTINGS PRODUCT SETUP
 GSSE / GOOSE
 CONFIGURATION
MESSAGE
The main transmission menu is shown below:

PATH: SETTINGS PRODUCT SETUP

TRANSMISSION
 TRANSMISSION

MESSAGE
MESSAGE
MESSAGE
The general transmission settings are shown below:

PATH: SETTINGS PRODUCT SETUP
 
TRANSMISSION GENERAL
 GENERAL

The
DEFAULT GSSE/GOOSE UPDATE TIME
put state changes to be sent. When remote output data changes, GSSE or GOOSE messages are sent immediately. This
setting controls the steady-state heartbeat time interval.
The
DEFAULT GSSE/GOOSE UPDATE TIME
The GSSE settings are shown below:

PATH: SETTINGS PRODUCT SETUP
 
TRANSMISSION GSEE
 GSSE

MESSAGE
MESSAGE
These settings are applicable to GSSE only. If the fixed GOOSE function is enabled, GSSE messages are not transmitted.
The setting represents the IEC 61850 GSSE application ID name string sent as part of each GSSE message. This
GSSE ID
string identifies the GSSE message to the receiving device. In T60 releases previous to 5.0x, this name string was repre-
sented by the setting.
RELAY NAME
GE Multilin
 
COMMUNICATIONS IEC 61850 PROTOCOL
 TRANSMISSION

 RECEPTION

 
COMMUNICATIONS IEC 61850 PROTOCOL
 GENERAL

 GSSE

 FIXED GOOSE

 CONFIGURABLE
 GOOSE
 
COMMUNICATIONS IEC 61850 PROTOCOL
DEFAULT GSSE/GOOSE
UPDATE TIME: 60 s
sets the time between GSSE or GOOSE messages when there are no remote out-
setting is applicable to GSSE, fixed T60 GOOSE, and configurable GOOSE.
 
COMMUNICATIONS IEC 61850 PROTOCOL
GSSE FUNCTION:
Enabled
GSSE ID:
GSSEOut
DESTINATION MAC:
000000000000
T60 Transformer Protection System
5.2 PRODUCT SETUP

GSSE/GOOSE CONFIGURATION

GSSE/GOOSE CONFIGURATION

GSSE/GOOSE CONFIGURATION
Range: 1 to 60 s in steps of 1

GSSE/GOOSE CONFIGURATION
Range: Enabled, Disabled
Range: 65-character ASCII string
Range: standard MAC address
5
5-43