Creating An Iscsi Attached Host - IBM V7000 Introduction And Implementation Manual

The CLI commands window displays, and after the task is completed, click Close. The
FC-attached host is now created successfully and it appears on the list of configured hosts.
You can right-click the server here to perform any additional configuration tasks as shown in
Figure 6-27.
Figure 6-27 The newly created host appears

6.2.2 Creating an iSCSI attached host

The process of creating a iSCSI attached host is almost similar to creating an FC-attached
host as shown in 6.2.1, "Creating a Fibre Channel attached host" on page 273. The only
difference is that instead of configuring the new host with WWNs from our host, we instead
configure an iSCSI initiator name. The iSCSI initiator name is obtained from the iSCSI initiator
software installed on the host computer and represents a unique, however changeable, iSCSI
address of our host on the network.
276
IBM Flex System V7000 Storage Node Introduction and Implementation Guide