Installing A 10 Gbps Iscsi-Fcoe 2-Port Host Interface Adapter - IBM Storwize V3700 Quick Installation Manual

10. Reinstall the SFP transceivers. To install a transceiver, push it fully into the
11. If you purchased the additional 2-transceiver option, install the extra SFP

Installing a 10 Gbps iSCSI-FCoE 2-port host interface adapter

If you purchased an FC ACHM 10 Gbps iSCSI-FCoE 2-port host interface adapter
that was not pre-installed for you, you must install it in the node canister.
Before you begin
The 10 Gbps iSCSI-FCoE 2-port host interface adapter is installed in the node
canisters in the control enclosure. If your control enclosure has two node canisters,
you must install the same options in both canisters. Do not start installation until
you have two of the 10 Gbps iSCSI-FCoE 2-port host interface adapter options.
Procedure
To install the host interface adapter, complete the following steps.
1. Remove each SFP transceiver from the host interface adapter. To remove an SFP
2. Remove the filler plate from the host interface adapter slot.
30
Storwize V3700: Quick Installation Guide
8. Apply pressure to the opposite edge of the host interface adapter to push the
adapter into the connector.
9. Check that the host interface adapter is installed squarely in its slot and
tighten the retaining thumbscrew 1 .
port and close the release handle.
transceivers in the remaining ports.
transceiver, swing the release handle open and use it to pull the transceiver out
of the port.
a. Loosen the retaining thumbscrew 1 as shown in Figure 19 on page 31.