Shutting Down Using Ibm Flex System V7000 Storage Node Command-Line; Interface; Powering Off A Node Using The Cmm - IBM V7000 Introduction And Implementation Manual

13.13.3 Shutting down using IBM Flex System V7000 Storage Node
command-line interface
You can also shut down IBM Flex System V7000 Storage Node by using the CLI and the
PuTTY utility. Run the stopcluster command to shut down the system.

13.13.4 Powering off a node using the CMM

Use this procedure when it is necessary to power off the Flex System V7000 Storage Node
using the CMM. Make sure you that select the correct node canister before proceeding.
Power off IBM Flex System V7000 Storage Node canister using the IBM Flex System V7000
Storage Node service GUI:
1. Open the CMM and navigate to the Chassis Map. The Chassis Map displayed by the CMM
provides a graphical view of the IBM Flex System Enterprise Chassis components. Using
the mouse, locate the node that you want to power off, as shown in Figure 13-52 on
page 626.
Caution: This operation can result in permanent loss of data on storage volumes or
loss of access to the volumes. Use the storage management user interface provided by
the storage node to power off the storage system or individual storage controllers.
Only continue if the service procedures have directed the use of this CMM power
control operation.
2. Click the node to display the Actions menu.
3. In the Actions menu, click Power Off. (Controller will shut down OS).
628
IBM Flex System V7000 Storage Node Introduction and Implementation Guide