IBM V7000 Introduction And Implementation Manual page 543

The IBM Flex System V7000 Storage Node initiator is discovered and connected
(Figure 12-17).
Figure 12-17 iSCSI Initiator target is connected
Now you have completed the steps to connect the storage disk to your iSCSI host, but you
are only using a single path at the moment. To enable multipathing for iSCSI targets, more
actions are required. Complete the following steps:
1. Click Start  Run and type cmd to open a command prompt. Enter
ServerManagerCMD.exe -install Multipath-IO and press Enter (Example 12-4).
Example 12-4 Installing MPIO
C:\Users\Administrator>ServerManagerCmd.exe -Install Multipath-IO
Start Installation...
[Installation] Succeeded: [Multipath I/O] Multipath I/O.
<100/100>
Success: Installation succeeded.
Chapter 12. Host configuration
523