IBM V7000 Introduction And Implementation Manual page 188

Initial setup
Follow this procedure for the initial setup from the CMM interface:
1. Log in to the CMM and navigate to the Chassis Map. In the Chassis Map displayed by the
CMM, you will see all the IBM Flex System V7000 Storage Node enclosures installed in
the chassis.
Tip: If you have installed more than one control enclosure in your IBM Flex System
V7000 Storage Node system, choose a control enclosure to be used to initialize the
system. It does not matter which control enclosure you choose. You cannot initialize the
system from an expansion enclosure.
2. Select the Actions menu and click Launch Storage Node Console. The Action menu
can be found by right-clicking the left canister in the graphical representation of the
storage node, as shown in Figure 4-8.
Figure 4-8 CMM - Select Launch Storage Node Console
3. A browser window displays the IBM Flex System V7000 Storage Node system startup
panel. The Service IP address displayed will be one that has been allocated by your
DHCP server as shown in Figure 4-9.
Figure 4-9 CMM - Launch Node Console
168
IBM Flex System V7000 Storage Node Introduction and Implementation Guide