The Upgrade Process - Wyse Winterm 3200LE Administrator's Manual

222
Firmware Upgrades
Table 33-1 Change DHCP Option IDs Dialog Box, Continued
Function
Reset To Defaults

The Upgrade Process

1. Press the F2 key for the Terminal Properties dialog box.
2. Click on the Network tab.
3. Click on the Obtain an IP Address From DHCP Server radio button, if the
function is not enabled.
4. Click on the Apps tab.
5. Click on the DHCP Automatic Update Enable check box on the Apps
properties sheet, if the function is not enabled.
6. If you want to change the DHCP option ID values, click on the Change DHCP
Option... command button.
7. Use the Change Option IDs dialog box to change options, then click on OK to
save.
Note
You have now enabled the automatic DHCP function.
You will also need to configure your DHCP option IDs.
Make sure your DHCP options match the options on
the DHCP server.
Note
Pay special attention to these FTP Option IDs
functions: File Server (the location of the server where
the firmware resides), and File Root Path (the location
of the firmware). If they are not correct, the upgrade will
fail.
Description
Click on this command button to reset all option IDs to
the default values.
Note
The values shown in Figure 33-1 are the
terminal default values.