Table of Contents
Advertisement
30
Cable Firmware Upgrades
The following section describes the cable method of firmware download. The cable
method for all terminals is parallel download, using a Laplink
MS-DOS xfer.exe program.
Setup
The following equipment may be needed, depending on the download procedure
used:
•
IBM-compatible PC with a CD-ROM drive and a parallel port.
•
Terminal firmware upgrade diskette or CD.
•
LapLink or equivalent parallel port communications cable (used only if parallel
port is used for downloading).
Note
This chapter applies only to Model 3320SE, 3350SE,
3360SE and 3720SE terminals.
Caution
Do not power the terminal off during the upgrade.
Note
For convenience, drive D:\ is used here for the CD
drive. You should substitute the appropriate drive letter
for your PC.
cable and the
Hide quick links:
Advertisement
Table of Contents
