Table of Contents
Advertisement
202
Firmware Upgrades
Parallel Flash Download Procedure
This procedure includes both manual and auto download instructions. The
download procedure will not work unless your PC is booted to DOS.
1. Record the terminal's current configuration.
2. Turn off the terminal.
3. Connect a parallel LapLink cable from the parallel port of your PC to the parallel
port of the terminal.
4. Insert the firmware upgrade CD into your PC.
5. Type D:\ at the DOS prompt to select the drive where the download files exist.
Use the dir command to find the files.
6. Perform either "Manual Download" or "Auto Download."
Manual Download
Use the following instructions to perform a manual download.
1. Type xfer <filename.ext> at the DOS prompt
2. Press Enter, and the Download Utility dialog box appears. See the following
figure.
Caution
All previous settings will be lost. Upgrading the
firmware defaults the current configuration to the
factory default settings.
Hide quick links:
Advertisement
Table of Contents
