Wyse Winterm 3200LE Administrator's Manual page 262

230
Security Properties
Table 34-1 Security Properties Sheet, Continued
Function
AutoLogin Enable
DHCP Connection
Enable
Auto Fail Recovery
Description
This group box is used to configure login parameters.
See "Autologin and Autoconnect" for more information
about autologin.
AutoLogin Enable
Click to enable the function. AutoLogin is enabled only
for the user name currently highlighted in the User
Accounts list box. Enabling the autologin function
activates Single Button Connect. By default the
function is disabled.
User Name
This field is activated by enabling AutoLogin Enable.
By default the field is blank.
Single Button Connect
Click to enable the function. See the chapter "Terminal
Login" for more information. By default the function is
not activated.
Use this group box to access the DHCP connection
list. It contains the following functions:
DHCP Connection Enable
Click to enable automatic DHCP connection. Enabling
this function activates the Connection Name and
Type list. By default this function is enabled.
Connection Name and Type
A scroll list that displays all connections available to
your terminal. You must select the connection that will
use information supplied by DHCP. By default this
function is Default ICA Connection {ICA}.
Click on the check box to enable the function. Auto Fail
Recovery is a function that checks the validity of a
disconnect, and closes down a connection if
disconnect checks true. By default the function is
activated but not enabled.