Memory Preset - Data Store/Load - HITEC X2 ACPro Operation Manual

Memory Preset - Data Save/Load
Memory Preset - Data Save/Load:
The Save Data and Load Data programs make it easy to store and load charge and
discharge profiles for up to 10 batteries per channel. Data can be saved for each
battery type and each charge mode available with the X2 AC Pro. This allows you to
recall data for each battery when charging or discharging without having to set up
the program over again. You can also edit settings for each saved battery.
Save Data:
[BATT MEMORY 1]
ENTER SET ->
ENTER/Start ► button to enter the battery memory program. In the corner of
the screen you will see the number 1 flashing, use the
through the memories. When you are ready to select a memory to program,
press the ► button again to enter the memory setup menu.
BATT TYPE
LiPo
(LiPo, LiFe, LiIon, LiHV, NiMH, NiCd or Pb), then press the ► button to confirm
your selection.
Now you will use
the + you will make adjustments in the following order, using the ▬ button will
reverse this order.
BATT VOLTS
7.4V ( 2S )
buttons to change the cell count then press the ► button to confirm your selection.
CHARGE CURRENT
4.9A
to change the charge current then press the ► button to confirm your selection.
DSCH CURRENT
2.0A
to change the discharge current then press the ► button to confirm your
selection.
36
From the BATT/PROGRAM menu use the
to scroll to the BATT MEMORY program and press the
Press the ► button again and the battery type will begin
to flash. Use the
+
or ▬ buttons to scroll through the battery parameters, using
Voltage and Number of Cells: Press the ► button and
the number of cells will begin to flash. Use the
Charge Current: Press the ► button and the charge
current value will begin to flash. Use the
Discharge Current: Press the ► button and the discharge
current value will begin to flash. Use the
+
or ▬ buttons to scroll
+
or ▬ buttons to select the battery type
+
or ▬ buttons
+
or ▬
+
or ▬ buttons
+
or ▬ buttons