HITEC X2 ACPro Operation Manual page 19

Lithium Battery Program
See page 12 for the appropriate charging connections setup for this operation.
LiPo BALANCE
2.7A 11.1V (3S)
battery type, press the ► button once to enter the charge mode and battery
settings screen, use the INC. ▬ or DEC
► button again and the amperage value will begin flashing. Use the
buttons to adjust the value to the desired charge rate. Follow the instructions
provided with your battery when setting the charge amperage rate.
Press the ► button again and the voltage value will begin flashing. Use the
or ▬ buttons to adjust the value to the desired rate. The voltage and cell count
should match the values listed on the battery label.
R:3SE R S:3SER
CANCEL(STOP)
R:3SE R S:3SER
CONFIRM(ENTER)
number of cells detected by the processor as "R" and the number of cells you set
as "S". If both numbers are identical, you may press and hold the ENTER/Start ►
button to confirm and begin charging. If these numbers do not match, press the
BATT/PROG Stop ■ button to return to the previous screen and carefully check
the number of cells of the battery pack before proceeding.
DURING CHARGING/DISCHARGING, THE BATTERY SHOULD BE PLACED
INSIDE A FIRE PROOF/RETARDANT BAG AND ON A FIRE PROOF SURFACE
Caution
AWAY FROM OTHER COMBUSTIBLE OBJECTS.
LP3s 2.7A 11.88V
BAL 005:39 00256
count, charging current, battery voltage, charging time and charged capacity.
To view the voltage of each individual cell charging, press the
also view a variety of other information as detailed later in this manual.
4.07 4.06 4.11V
0.00 0.00 0.00V
Press the ■ button to return to the setup screen. You may also press the ■
button at any time during the charging process to stop charging.
[LiP0/LiHV/LiFe/Lilon cont.]
First, select the correct battery type by following the
instructions on page 16. Once you have set the correct
+
to select a "CHARGE" mode. Press the
You are now ready to begin charging. Press and hold the
ENTER/Start ► button until you see "BATTERY CHECK, "
followed by the "CONFIRM (ENTER) / CANCEL(STOP)"
screen. The "CONFIRM/CANCEL" screen displays the
Once charging has commenced, the charger will display
the following real-time information: battery type/cell
Once the battery is fully charged, the screen will read
"FINISHED" and the charger will emit a chiming sound.
+
or ▬
+
+
button. You can
19