HITEC X2 ACPro Operation Manual page 20

Lithium Battery Program
Lithium Fast Charge Mode:
Charging in Fast Charge Mode allows for a shorter charge time and will result
in a slightly reduced charging capacity. To achieve maximum charge capacity,
we recommend you use the Lithium Balance Charge Mode. If a fast charge
is necessary, select the fast charge mode and follow the same charging
instructions as for the Lithium Charge Mode or Lithium Balance Charge Mode.
BEFORE YOU BEGIN CHARGING YOUR BATTERY, MAKE SURE YOU
HAVE READ AND UNDERSTAND ALL OF THE WARNINGS AND SAFETY
Warning
INFORMATION CONTAINED ON PAGES 02-07.
IN THE CHARGE MODE, LITHIUM BATTERIES CAN BE CHARGED WITHOUT
THE USE OF A BALANCE ADAPTOR. A BALANCE ADAPTOR CAN BE USED,
Note
BUT IT IS NOT REQUIRED. BALANCE CHARGE MODE IS RECOMMENDED
FOR ANY BATTERY WITH A BALANCE LEAD.
See page 12 for the appropriate charging connections setup for this operation.
4.07 4.06 4.11V
0.00 0.00 0.00V
battery type, press the ► button once to enter the charge mode and battery
settings screen, use the INC. ▬ or DEC
► button again and the amperage value will begin flashing. Use the
buttons to adjust the value to the desired charge rate. Follow the instructions
provided with your battery when setting the charge amperage rate.
Press the ► button again and the voltage value will begin flashing. Use the
or ▬ buttons to adjust the value to the desired rate. The voltage and cell count
should match the values listed on the battery label.
R:3SE R S:3SER
CANCEL(STOP)
R:3SE R S:3SER
CONFIRM(ENTER)
cells detected by the processor as "R" and the number of cells you set as "S". If both
numbers are identical, you may press and hold the ENTER/Start ► button to confirm
and begin charging. If these numbers do not match, press the BATT/PROG Stop ■
button to return to the previous screen and carefully check the number of cells of
the battery pack before proceeding.
20
[LiP0/LiHV/LiFe/Lilon cont.]
First, select the correct battery type by following the
instructions on page 16. Once you have set the correct
+
to select a "CHARGE" mode. Press the
You are now ready to begin charging. Press and hold the
ENTER/Start ► button until you see "BATTERY CHECK, "
followed by the "CONFIRM (ENTER) / CANCEL(STOP)" screen.
The "CONFIRM/CANCEL" screen displays the number of
+
or ▬
+