Operation - HITEC X2 ACPro Operation Manual

Operation

Switch from
Channel A to B or
Channel B to A
Scroll Through the Main Menu
Stop Any Charge Processes
CH A/CH B:
Switch from Channel A to B or from Channel B to A.
BATT PROG / STOP Button:
Stop a function in progress or to go back to previous step/screen.
DEC Button:
Scroll through menus or decrease the parameter value.
INC Button:
Scroll through the menus or increase the parameter value.
ENTER / START Button:
Enter parameters or store parameters on-screen.
When changing a parameter value in the program, press the START/ENTER
button to make it blink, then change the value by pressing the INC ▬ or DEC
buttons. The value will be stored by re-pressing the START/ENTER button. If there
is a second parameter to edit on the same screen, it will begin blinking after you
confirm the first parameter value.
When you power the charger on, it will automatically enter the LiPo Battery
balance program screen. You can change the mode (balance mode, normal
charge mode, fast charge mode, store mode, or discharge mode), enter the
desired charging/discharging mode, or set the preferred parameter to begin. If
there are no changes to make in the LiPo Battery program, press the BATT PROG/
STOP button to enter the BATT PROGRAM screen.
14
Resume or Start Charge
Processes Confirm Any Action
Alter Values
See the Status of Individual
Cells in Balance Charge Mode
+