HITEC X2 ACPro Operation Manual page 28

NiCd/NiMH Battery Program [
NiMH 1.3A 10.42V
RPC 004:04 00686
charging current, battery voltage, elapsed time and charged capacity.
Once the Re-Peak process has completed, the screen will read "END: RE-PEAK"
and the charger will emit a chiming sound. The X2 AC Pro will display the
charge/discharge capacity for each cycle. Using the
scroll through this data for each cycle.
NiCd/NiMH Cycle Mode:
The X2 AC Pro makes cycling of NiCd/NiMH batteries easy. The process of
discharging and recharging (cycling) can be achieved automatically with one
simple step and will improve the performance of NiCd/NiMH batteries. We
strongly recommend cycling any battery that has been discharged and stored
for a period of time. This will increase battery life and improve performance.
BEFORE YOU BEGIN CHARGING YOUR BATTERY, MAKE SURE YOU
HAVE READ AND UNDERSTAND ALL OF THE WARNINGS AND SAFETY
Warning
INFORMATION CONTAINED ON PAGES 02-07.
FOR CYCLING, THE X2 AC PRO USES THE CHARGE/DISCHARGE AMPERAGE
AND VOLTAGE SETTINGS ENTERED IN THE CHARGE AND DISCHARGE
Note
MODES (SEE PAGE 16).
NiMH CYCLE
DCHG > CHG
you two cycling options: "DCHG>CHG" or "CHG>DCHG". The "DCHG>CHG" option
will first discharge the battery and then charge the battery.
NiMH CYCLE
CHG > DCHG
show the cycling option you desire, press the ► button once and this setting will
begin flashing. Use the
Pressing the ► button again will cause the number of cycles option to begin
+
flashing. Use the
the X2 AC Pro to run. The X2 AC Pro can cycle the battery a maximum of 5 times
consecutively.
Press and hold the ► button and cycling will begin.
28
Once the Re-Peak process has begun, the charger will
display the following real-time information: battery type,
After selecting the correct battery type, use the
buttons to select the "CYCLE" mode. The Cycle Mode gives
2
The "CHG>DCHG" option will first charge the battery and
then discharge the battery. If this screen does not currently
5
+
or ▬ buttons to change this setting.
or ▬ buttons to change this to the number of cycles you want
cont.]
+
and ▬ buttons, you can
+
or ▬