HITEC X2 ACPro Operation Manual page 23

Lithium Battery Program
DISCHARGING LITHIUM CHEMISTRY BATTERIES CAN CAUSE PERMANENT
DAMAGE TO THE BATTERY AND IT IS NOT RECOMMENDED FOR
Warning
ANYTHING OTHER THAN THE DISPOSAL OF THE BATTERY. IF YOU CHOOSE
TO DISCHARGE YOUR LITHIUM BATTERIES, MAKE SURE TO PAY CLOSE
ATTENTION TO THE MINIMUM VOLTAGE SETTING. IF YOU WANT TO STORE
YOUR BATTERY FOR A LONG PERIOD OF TIME, YOU SHOULD UTILIZE THE
STORAGE MODE CHARGE PROGRAM AS THIS IS THE SAFEST METHOD OF
STORING YOUR LITHIUM CHEMISTRY BATTERIES.
IN DISCHARGE MODE, LITHIUM BATTERIES CAN BE DISCHARGED
WITH OR WITHOUT THE USE OF A BALANCE ADAPTOR. THE USE OF
Note
A BALANCE ADAPTOR IS RECOMMENDED FOR DISCHARGING ANY
BATTERY THAT HAS A BALANCE LEAD.
See page 12 for the appropriate charging connections setup for this operation.
LiPo DISCHARGE
2.7A 11.1V (3S)
battery type, press the ► button once to enter the charge mode and battery
settings screen, use the INC. ▬ or DEC
► button again and the amperage value will begin flashing. Use the
buttons to adjust the value to the desired charge rate. Follow the instructions
provided with your battery when setting the charge amperage rate.
Press the ► button again and the voltage value will begin flashing. Use the
or ▬ buttons to adjust the value to the desired rate. The voltage and cell count
should match the values listed on the battery label.
R:3SE R S:3SER
CANCEL(STOP)
R:3SE R S:3SER
CONFIRM(ENTER)
number of cells detected by the processor as "R" and the number of cells you set
as "S". If both numbers are identical, you may press and hold the ENTER/Start ►
button to confirm and begin charging. If these numbers do not match, press the
BATT/PROG Stop ■ button to return to the previous screen and carefully check
the number of cells of the battery pack before proceeding.
[LiP0/LiHV/LiFe/Lilon cont.]
First, select the correct battery type by following the
instructions on page 16. Once you have set the correct
+
to select a "CHARGE" mode. Press the
You are now ready to begin charging. Press and hold the
ENTER/Start ► button until you see "BATTERY CHECK, "
followed by the "CONFIRM (ENTER) / CANCEL(STOP)"
screen. The "CONFIRM/CANCEL" screen displays the
+
or ▬
+
23