HITEC X2 ACPro Operation Manual page 22

Lithium Battery Program
Press the ► button again and the voltage value will begin flashing. Use the
or ▬ buttons to adjust the value to the desired rate. The voltage and cell count
should match the values listed on the battery label.
R:3SE R S:3SER
CANCEL(STOP)
R:3SE R S:3SER
CONFIRM(ENTER)
number of cells detected by the processor as "R" and the number of cells you set
as "S". If both numbers are identical, you may press and hold the ENTER/Start ►
button to confirm and begin charging. If these numbers do not match, press the
BATT/PROG Stop ■ button to return to the previous screen and carefully check
the number of cells of the battery pack before proceeding.
DURING CHARGING/DISCHARGING, THE BATTERY SHOULD BE PLACED
INSIDE A FIRE PROOF/RETARDANT BAG AND ON A FIRE PROOF SURFACE
Caution
AWAY FROM OTHER COMBUSTIBLE OBJECTS.
LP3s 2.7A 11.88V
STO 005:39 00256
count, charging current, battery voltage, charging time and charged capacity.
4.07 4.06 4.11V
0.00 0.00 0.00V
individual cell. You can also view a variety of other information as detailed later
in this manual.
Once the battery has reached storage level, the screen will read "STORAGE
FINISHED" and the charger will emit a chiming sound. Press the ■ button to
return to the setup screen. You may also press the ■ button at any time during
the process to stop.
Lithium Discharge Mode:
If you plan to discharge your battery to reach safe storage levels, we strongly
recommend that you use Storage Mode. In very few instances, discharging may
become necessary with LiPo batteries. One such instance may include preparing
a battery for disposal, in which case the battery should not be completely
discharged. Be sure to follow the discharging instructions provided by the
battery manufacturer. Over-discharging a battery can severely damage the
battery and may cause a fire or explosion.
22
[LiP0/LiHV/LiFe/Lilon cont.]
You are now ready to begin charging. Press and hold the
ENTER/Start ► button until you see "BATTERY CHECK, "
followed by the "CONFIRM (ENTER) / CANCEL(STOP)"
screen. The "CONFIRM/CANCEL" screen displays the
Once charging has commenced, the charger will display
the following real-time information: battery type/cell
If you are using a balance adaptor during charging, you
+
may press the button to view the voltage of each
+