Table of Contents
Advertisement
Advanced System Set Up [
ITEM
NiMH Sensitivity
D.Peak
Default
NiMH Sensitivity
D.Peak
Default
Keep Beep
Buzzer
Input
Power Low
Cut-Off
11.0V
AC Max Power Set
Load Factory Set
Enter
Version
HW:1.00
FW:1.10
Bal. Connection
SELECTION
Default:
4mV/Cell
5-15mV/Cell
ON
OFF / ON
ON
10.0-11.0V
0-100W
50W
OFF / ON
cont.]
DESCRIPTION
This program is for NiMH/NiCd batteries
only. When the charger detects that the
delta peak value has reached the value
you set, the charger will say the battery is
fully charged.
The beep sounds every time you touch
the buttons to confirm your action. The
beep or melody sounds at various times
during operation to alert different mode
changes.
This program monitors the voltage of the
input battery. If the voltage drops below
the value you set, the operation forcibly
terminates to protect the input battery.
This is to set the max AC power of the
present channel. Once you set it, the
other channel will take the remaining
wattage.
Press ENTER to load the factory default
setting.
This indicates the hardware and firmware
version.
Turns balance adapter detection ON or
OFF.
39
Advertisement
Table of Contents
