HITEC X2 ACPro Operation Manual page 21

Lithium Battery Program
DURING CHARGING/DISCHARGING, THE BATTERY SHOULD BE PLACED
INSIDE A FIRE PROOF/RETARDANT BAG AND ON A FIRE PROOF SURFACE
Caution
AWAY FROM OTHER COMBUSTIBLE OBJECTS.
LP3s 2.7A 11.88V
FAS 005:39 00256
charging current, battery voltage, charging time and charged capacity.
4.07 4.06 4.11V
0.00 0.00 0.00V
cell. You can also view a variety of other information as detailed later in this manual.
Once the battery is fully charged, the screen will read "FINISHED" and the
charger will emit a chiming sound. Press the ■ button to return to the setup
screen. You may also press the ■ button at any time during the charging
process to stop charging.
Lithium Storage Mode:
This function is for charging/discharging batteries that will not be used
immediately. The program is designed for charging/discharging batteries up-to or
down-to safe storage levels. The program will automatically begin to discharge if
the current state of the battery exceeds the voltage level for storage.
BEFORE YOU BEGIN CHARGING YOUR BATTERY, MAKE SURE YOU
HAVE READ AND UNDERSTAND ALL OF THE WARNINGS AND SAFETY
Warning INFORMATION CONTAINED ON PAGES 02-07.
IN STORAGE MODE, LITHIUM BATTERIES CAN BE CHARGED WITHOUT
THE USE OF A BALANCE ADAPTOR. A BALANCE ADAPTER CAN BE USED,
BUT IT IS NOT REQUIRED. BALANCE CHARGE MODE IS RECOMMENDED
Note
FOR ANY BATTERY WITH A BALANCE LEAD.
LiPo STORAGE
2.7A 11.1V (3S)
First, select the correct battery type by following the instructions on page 16. Once
you have set the correct battery type, press the ► button once to enter the charge
mode and battery settings screen, use the INC. ▬ or DEC
mode. Press the ► button again and the amperage value will begin flashing.
+
or ▬ buttons to adjust the value to the desired charge rate. Follow the
Use the
instructions provided with your battery when setting the charge amperage rate.
[LiP0/LiHV/LiFe/Lilon cont.]
Once charging has commenced, the charger will display
the following real-time information: battery type/cell count,
If you are using a balance adaptor during charging, you may
+
press the button to view the voltage of each individual
See page 12 for the appropriate charging connections
setup for this operation.
+
to select a "CHARGE"
21