Charger Operation - HITEC X2 ACPro Operation Manual

Charger Operation

The following section contains detailed procedures that must be followed to make
the charger work. When you power the charger on, it will automatically enter the
LiPo Battery balance program screen. Use the CHA/CHB button to toggle between
channels A and B and the BATT PROG/STOP button to enter the BATT PROGRAM
screen. Once in the Battery Programming section, use the < or > to select the
desired battery or function then press ENTER/Start to make your parameter
adjustments. The X2 AC Pro is capable of the following processes based on the
type of battery chosen.
Batt Operation
Type Program
CHARGE
DISCHARGE
LiPo
STORAGE
LiIon
LiFe
LiHV
FAST CHG
BAL CHARGE
CHARGE
AUTO CHG
NiMH
NiCd
DISCHARGE
RE-PEAK
CYCLE
CHARGE
Pb
DISCHARGE
16
This charging mode is for charging LiPo/LiFe/LiIon/LiHV batteries in normal mode.
This mode is for discharging LiPo/LiFe/LiIon/LiHV batteries.
This program is for charging or discharging lithium battery which will not be used for
a long time.
The charging capacity may be less than normal charging but the process time will
be reduced.
This mode is for balancing the voltage of lithium-polymer battery cells while charging.
The charger will charge NiMH and NiCd batteries using the charger current set by
the user.
In this program, the charger detects the condition of the batteries which is connected to
the output and automatically charges the batteries.
Note: You should set up the upper limit of the charge current to avoid damage by
excessive feeding current. Some batteries of low resistance and capacity can lead
to higher current.
This mode is for discharging NiMH/NiCd batteries.
In re-peak charge mode, the charger can peak charge the battery once, twice or three
times in a row automatically. This is good for confirming the battery is fully charged and
for checking how well the battery receives fast charges.
1 to 5 cyclic and continuous process of charge > discharge or discharge > charge is
operable for battery refreshing and balancing to stimulate the battery's activity.
This mode is for charging Pb batteries.
This mode is for discharging Pb batteries.
Description