HITEC X2 ACPro Operation Manual page 37

Memory Preset - Data Save/Load [
DSCH VOLTAGE
3.0V/CELL
+
or ▬ buttons to change the per cell discharge voltage, then press the ►
the
button to confirm your selection.
MAKE SURE TO FOLLOW YOUR BATTERY MANUFACTURER'S
RECOMMENDATIONS REGARDING DISCHARGING. FAILURE TO DO SO
Warning
MAY DESTROY THE BATTERY OR RENDER IT UNSAFE FOR USE.
TVC = YOU R RISK
4.20V
to change the terminal voltage, and then press the ► button to confirm your
selection.
CHANGING THE TERMINAL VOLTAGE IS ONLY INTENDED FOR EXPERT
USERS, ANY CHANGES TO DEFAULT SETTINGS ARE COMPLETELY AT YOUR
Warning OWN RISK.
SAVE PROGRAM
ENTER
SAVE PROGRAM
SAVE...
[ BATT MEMORY 1 ]
LiPo 7.4V (2S)
[ BATT MEMORY 1 ]
C:4.9 D:2.2 A
Recall Memory:
ENTER CHARGER
LOAD...
enter the battery memory program . Use the
memories. When you have found the memory you would like to use, press the ►
button again to recall the memory.
LiPo BALANCE CHG
4.9A 7.4V (2S)
you would like to execute for the battery then press and hold the ► button for 3
seconds to begin the selected process.
Per Cell Discharge Voltage: Press the ► button and the
per cell discharge voltage value will begin to flash. Use
Terminal Voltage: Press the ► button and the terminal
voltage value will begin to flash. Use the
Save Program: Press the ► button to save the program.
SAVE..... will appear momentarily while the program is
written to the memory.
Once saved, the screen indicates the memory number,
battery type, cell count, charge current and discharge
current.
From the BATT/PROGRAM menu use the
scroll to the BATT MEMORY program and press ► button to
+
or ▬ buttons to scroll the available process
Use the
(charge, discharge, balance charge etc.). Select the process
cont.]
+
+
or ▬ buttons to scroll through the
+
or ▬ buttons
or ▬ buttons to
37