HITEC X2 ACPro Operation Manual page 30

Pb Lead-Acid Battery Program [
Pb Charge Mode:
BEFORE YOU BEGIN CHARGING YOUR BATTERY, MAKE SURE YOU
HAVE READ AND UNDERSTAND ALL OF THE WARNINGS AND SAFETY
Warning
INFORMATION CONTAINED ON PAGES 02-07.
After selecting the correct battery type, use the
"CHARGE" mode.
Press the ► button and the amp rate value will begin flashing. Use the
buttons to adjust the value to the desired charge rate. The amp rate should be set
to 1/10 of capacity. For example, if you are charging a 7Ah battery the charge rate
should be set to 0.7A. Follow the instructions provided with your battery when
setting the amp rate.
Pb Charge
1.5A 12.0V(6P)
and number of cells.
Press and hold the ► button and charging will begin.
P-6 1.5A 13.56V
CHG 002:22 00106
current, battery voltage, charging time and charged capacity.
When charging is complete, the screen will read "FINISHED" and the charger will emit
a chiming sound.
Pb Discharge Mode:
BEFORE YOU BEGIN CHARGING YOUR BATTERY, MAKE SURE YOU
HAVE READ AND UNDERSTAND ALL OF THE WARNINGS AND SAFETY
Warning
INFORMATION CONTAINED ON PAGES 02-07.
After selecting the correct battery type, use the
"DISCHARGE" mode.
Press the ► button and the amp rate value will begin flashing. Use the
buttons to adjust the value to the desired charge rate. The amp rate should be set
to 1/10 of capacity. For example, if you are discharging a 7Ah battery the discharge
rate should be set to 0.7A. Follow the instructions provided with your battery when
setting the amp rate.
30
Press the ► button again and the voltage rate value will
begin flashing. Use the
Once charging has commenced, the charger will display
the following real-time information: battery type, charging
cont.]
+
or ▬ buttons to change it to the
+
or ▬ buttons to set the voltage
+
or ▬ buttons to change it to the
+
or ▬
+
or ▬