Charger Connections - HITEC RDX1 MiNi Instruction Manual

Charger Connections

1.) Connecting to Power Source:
The RDX 1 Mini is an AC charger only. Please insert the AC power cord to the wall socket (100-240V)
directly to power it on.
2.) Connecting the Battery:
The safest way to set up the charger is to complete the program setup before connecting the battery,
as it is absolutely essential to make sure that the parameters are setup correctly. Please refer to the
propgramming section beginning on page 15 before attempting to use the charger.
Depending on the type of battery you have, you may have to use Connect your battery's connector to the
XT60 output on the charger (use adapter as needed).
3.) Balance Socket:
For Lithium Batteries in all modes
The balance wire attached to the battery must be connected to the charger, with the black wire aligned
with the negative marking on the right edge. Take care to maintain correct polarity. (See wiring
diagram below) Depending on the type of battery you have you may have to use a balance adapter.
Adapter are usually available wherever RC hobby products are sold.
This diagram shows the correct way to connect your battery to the Hitec RDX1 Mini when charging in
the balance charge program mode.
(-) (-)
WARNING:
Failure to connect as shown in this diagram
will damage your charger.
Note the polarity with the black (-) wire to
the right side of each connection.
13