Configuring Console Port Connection; Configuring Telnet Connection - Zte ZXR10 ZSR V2 Configuration Manual (System Management

ZXR10 ZSR V2 Configuration Guide (System Management)
l Trivial File Transfer Protocol (TFTP)/File Transfer Protocol (FTP) mode: Users
can use this mode to download/upload router configuration files, and update router
configurations.

1.2 Configuring Console Port Connection

This procedure describes how to connect to the ZXR10 ZSR V2 through the Console port.
Steps
1. Configure a Hyperterminal.
For how to configure a Hyperterminal, refer to the "Configuring the Device Through a
Console Port" section in the ZXR10 M6000 Initial Configuration Guide.
2. (Optional) In the configuration mode, run the login authentication command to enable
the Console port connection authentication function.
The Console port connection authentication function can be enabled only after a
username and password are configured. If the username and password are not
configured properly, after the function is enabled, you cannot enter the ZXR10> CLI
when you connect the device next time.
The following example shows how to enable Console port authentication.
ZXR10(config)#login authentication
Warning:
Please make sure local or remote authentication is correctly configured.
Are you sure to configure console authentication? [yes/no]:y
ZXR10(config)#
/*Enables the Console port connection authentication function.*/
For how to configure a user name and password used in serial port authentication,
refer to
– End of Steps –

1.3 Configuring Telnet Connection

This procedure describes how to connect to the ZXR10 ZSR V2 through Telnet.
Prerequisite
The local terminal can access the remote router network.
SJ-20140504150128-007|2014-05-10 (R1.0)
Caution!
4.2 Configuring User Management.
1-2
ZTE Proprietary and Confidential