Chapter 15 Network Layer Detection; Figure 15-1 Icmp Fast Response Configuration Example - Zte ZXR10 ZSR V2 Configuration Manual (System Management

Figure 15-1 ICMP Fast Response Configuration Example

l
Configuration Flow
1. Configure IP addresses of R1 and R2 interfaces.
2. Test the configuration result to make sure that the ICMP fast response (ping)
function is enabled between R1 and R2.
l
Configuration Commands
Run the following commands on R1:
R1(config)#interface gei-1/1
R1(config-if-gei-1/1)#no shutdown
R1(config-if-gei-1/1)#ip address 10.1.1.1 255.255.255.0
R1(config-if-gei-1/1)#exit
Run the following commands on R2:
R2(config)#interface gei-1/1
R2(config-if-gei-1/1)#no shutdown
R2(config-if-gei-1/1)#ip address 10.1.1.2 255.255.255.0
R2(config-if-gei-1/1)#exit
l
Configuration Verification
Run the following command to check the configurations on R1. The execution result
is displayed as follows:
R1#ping 10.1.1.2
sending 5,100-byte ICMP echoes to 10.1.1.2,timeout is 2 seconds.
!!!!!
Success rate is 100 percent(5/5),round-trip min/avg/max= 1/1/21 ms.
Run the following command to check the configurations on R2. The execution result
is displayed as follows:
R2#ping 10.1.1.1
sending 5,100-byte ICMP echoes to 10.1.1.2,timeout is 2 seconds.
!!!!!
Success rate is 100 percent(5/5),round-trip min/avg/max= 1/1/21 ms.
Note:
The ICMP fast response function is enabled by default. If the corresponding debug
function is enabled and then ping is performed, the ICMP fast response (ping) function
is disabled.
SJ-20140504150128-007|2014-05-10 (R1.0)

Chapter 15 Network Layer Detection

15-3
ZTE Proprietary and Confidential