Zte ZXR10 ZSR V2 Configuration Manual (System Management page 80

ZXR10 ZSR V2 Configuration Guide (System Management)
Configuration Flow
1. Enable the SNMP anti–brute force attack function.
2. Configure the ageing time for dynamic trusted users.
3. Configure static trusted users that are allowed to access the system.
4. Configure a Trap message and log that is generated when user attempts fail and a
state is switched.
Configuration Command
Run the following commands on the ZXR10 ZSR V2:
R1(config)#snmp-server security block 180 3 180 when 50 60
R1(config)#snmp-server security dynamic-trust-user idle-timeout 100
R1(config)#snmp-server security static-trust-user 169.1.110.6
R1(config)#snmp-server security on-failure log and Trap
Configuration Verification
Run the following command to check SNMP configurations. The execution result is
displayed as follows.
R1(config)#show running-config snmp
!<oam_snmp>
snmp-server security block 180 3 180 when 50 60
snmp-server security dynamic-trust-user idle-timeout 100
snmp-server security on-failure log and Trap
snmp-server security static-trust-user 169.1.110.6
!</oam_snmp>
6-14
SJ-20140504150128-007|2014-05-10 (R1.0) ZTE Proprietary and Confidential