Zte ZXR10 ZSR V2 Configuration Manual (System Management page 147

Configuration Flow
1. Enter LLDP configuration mode.
2. Configure LLDP attributes.
Configuration Command
The configuration of R1:
R1(config)#lldp
R1(config-lldp)#maxneighbor 3
/*Configure the maximum number of system neighbors*/
R1(config-lldp)#hellotime 30000
/*Configure the intervals to send LLDP neighbor discovery packets*/
R1(config-lldp)#holdtime 8
/*Configure LLDP neighbor hold-time*/
R1(config-lldp)#lldp enable
/*Enable LLDP*/
R1(config-lldp)#lldp-rx enable
/*Enable LLDP receiving*/
R1(config-lldp)#lldp-tx enable
/*Enable LLDP sending*/
R1(config-lldp)#clearneighbor
/*Clear LLDP neighbor relationship that has been established*/
R1(config-lldp)#clearstatistic
/*Clear LLDP statistical information*/
R1(config-lldp)#end
Configuration Verification
Use the show running-config lldp command to check the configuration result.
ZXR10#show running-config lldp
! <LLDP>
lldp
hellotime 30000
holdtime 8
maxneighbor 3
! </LLDP>
SJ-20140504150128-007|2014-05-10 (R1.0)
14-7
ZTE Proprietary and Confidential
Chapter 14 LLDP Configuration