Zte ZXR10 ZSR V2 Configuration Manual (System Management page 122

ZXR10 ZSR V2 Configuration Guide (System Management)
Step
3. Configure a NetFlow sampling policy.
Step
1
2
deterministic : uses deterministic sampling, that is, if the sampling rate is N, then one
packet out of every N packets is sampled.
<rate>: sampling rate, range: 1–65535, default: 1000.
4. Configure a NetFlow monitoring policy.
Step
1
2
SJ-20140504150128-007|2014-05-10 (R1.0)
Command
ZXR10(config-flow-record)#
{destination-port | icmp {ipv4 | ipv6}{code | type}|
source-port | tcp flags}
ZXR10(config-flow-record)#
protocol | version}
ZXR10(config-flow-record)#
{[destination address | address-prefix minimum
-mask <len>]|[source addressaddress-prefix
minimum-mask <len>]| flow-label}
Command
sampler <sampler-name>
ZXR10(config)#
ZXR10(config-sampler)#
1– – – out-of<rate>
Command
flow monitor <monitor-name>
ZXR10(config)#
ZXR10(config-flow-monitor)#
<num>| timeout {active | inactive}<seconds>}
collect transport
collect ip {cos|
collect ipv6
mode deterministic
cache {entries
12-6
ZTE Proprietary and Confidential
Function
Sets transport layer information
as a non-key field.
Sets IP information as a non-key
field.
Sets IPv6 information as a
non-key field. Range of len:
1–128.
Function
Creates a sampler policy,
and names it. Up to 200
different sampler policies can be
configured.
Range of the policy name: 1–12
characters.
Sets the sampling mode and
sampling rate.
Function
Creates a flow monitor policy,
and names it. Up to 60 different
flow monitor policies can be
configured.
Range of the policy name: 1–32
characters
Sets cache information.