Zte ZXR10 ZSR V2 Configuration Manual (System Management page 123

Step
3
4
entries <num>: sets the buffer size to num, which represents the number of flows that
can be stored in the buffer. Range: 16–131072, default: 4096.
timeoutactive<seconds>: active ageing time, unit: second, range: 10–604800, default:
1800.
timeoutinactive<seconds>}: inactive ageing time, unit is second, range: 10–604800,
default: 1800.
record <record-name>: uses a pre-set flow record policy as the template.
record netflow-original: predefines the v5 template. Collected key and non-key fields
are consistent with those of netflow v5.
netflow ipv4 protocol-port: predefines the v8 module.
5. Configure a NetFlow interface.
Step
1
2
SJ-20140504150128-007|2014-05-10 (R1.0)
Command
ZXR10(config-flow-monitor)#
<exporter-name>
ZXR10(config-flow-monitor)#
e>|netflow ipv4 protocol-port|netflow-original}
Command
interface <interface-name>
ZXR10(config)#
ZXR10(config-if-interface-name)#
flow monitor <monitor-name>[sampler
<sampler-name>][unicast|multicast|ipv4–access-list
<name>]{input|output}
ZXR10(config-if-interface-name)#
flow monitor <monitor-name>[sampler
<sampler-name>][unicast | multicast | ipv6–access-list
<name>]{input | output}
ZXR10(config-if-interface-name)#
monitor <monitor-name>[sampler <sampler-name>]
unicast {input | output}
Chapter 12 NetFlow Configuration
exporter
record {<record-nam
ip
ipv6
mpls flow
12-7
ZTE Proprietary and Confidential
Function
Associates a flow exporter policy.
Associates a pre-set flow exporter
policy. That is, the flow monitor
policy uses the flow exporter
policy for the output of netflow
packets. If the flow exporter
policy uses v5 output format,
the template used by the flow
monitor must be the pre-set
netflow-original.
Sets the template to be used.
Function
Enters interface configuration
mode.
Configures IPv4 packets
sampling on the interface.
Configures IPv6 packets
sampling on the interface.
Configures MPLS packet
sampling on the interface.