Zte ZXR10 ZSR V2 Configuration Manual (System Management page 111

Keepalive set: 10 sec(s)
LCP INITIAL, IPCP INITIAL, BCPINITIAL, IPV6CP INITIAL
MPLSCP INITIAL, OSINLCP INITIAL
Last Clear Time : 2000-04-02 01:49:43 Last Refresh Time:2000-04-02 01:49:43
120s input rate : 0Bps 0Pps
120s output rate: 0Bps 0Pps
Intf utilization: input 0% output 0%
HardWareCounters:
In_Bytes 0 In_Packets 0
In_Abort 0 In_OverFlow N/A
In_Runt 0 In_Giant 0
R2(config-if-pos3-1/1)#show interface pos3-1/1
pos3-1/1 is down, line protocol is down
Description is none
Hardware is Packet Over SONET/SDH
Internet address is unassigned
IP MTU 4470 bytes
MTU 4600 bytes
BW 155520 Kbits
MPLS MTU 4470 bytes
Physical layer is Packet over (SDH)
Holdtime is 120 sec(s)
CRC 32
Loopback cancel
Clock Source: internal
Scramble enable
Encapsulation PPP
Keepalive set: 10 sec(s)
LCP INITIAL, IPCP INITIAL, BCPINITIAL, IPV6CP INITIAL
MPLSCP INITIAL, OSINLCP INITIAL
Last Clear Time : 2000-04-02 01:49:43 Last Refresh Time:2000-04-02 01:49:43
120s input rate : 0Bps 0Pps
120s output rate: 0Bps 0Pps
Intf utilization: input 0% output 0%
HardWareCounters:
In_Bytes 0 In_Packets 0
In_Abort 0 In_OverFlow N/A
In_Runt 0 In_Giant 0
SJ-20140504150128-007|2014-05-10 (R1.0)
Chapter 10 Clock and Clock Synchronization
10-9
ZTE Proprietary and Confidential