Panasonic KX-TDA100D Features Manual page 68

1.3.1 Call Forwarding (FWD)/Do Not Disturb (DND)
The FWD/DND status for trunk calls to that extension can be switched temporarily without clearing the
FWD destination. During setting, the LED of the button shows the current trunk call FWD/DND status. The
forwarding type and destination for trunk calls can also be set.
•
FWD/DND for intercom calls
The FWD/DND status for intercom calls to that extension can be switched temporarily without clearing the
FWD destination. During setting, the LED of the button shows the current intercom call FWD/DND status.
The forwarding type and destination for intercom calls can also be set.
•
FWD—No Answer timer
The length of time until unanswered calls are forwarded can be modified. This setting is applied to both
intercom and trunk call forwarding.
•
FWD for Virtual PS
If the extension is the first registered extension in an Incoming Call Distribution Group, the extension user
can set the FWD destination and forwarding status (on/off) for up to 4 virtual PSs preregistered to the group.
(® 1.25.6 Virtual PS)
These settings are only available when FWD/DND buttons are set through system programming to FWD/DND
Setting mode.
Conditions
•
When FWD/DND buttons are set to FWD/DND Cycle Switch mode, pressing the FWD/DND button cycles
the FWD/DND setting.
In this mode, when intercom calls are set to be handled differently from trunk calls (forwarding type, forward
destination, DND on/off):
a.
in idle mode, the light patterns of the FWD/DND—Both button (including FWD/DND button [fixed
button]) and the Group FWD—Both button will indicate the setting for either trunk calls or intercom
calls, but not both.
b.
the FWD and DND icons on a PS display reflect the settings for trunk calls only.
c.
pressing the FWD/DND—Both button (including FWD/DND button [fixed button]) or the Group FWD—
Both button will be ignored.
•
When both the FWD and DND features are assigned simultaneously, pressing the button changes the
settings as follows:
FWD
•
A FWD/DND button customised on a flexible button is always in FWD/DND Cycle Switch mode, and the
mode cannot be changed.
Feature Guide References
1.20.1 Fixed Buttons
1.20.2 Flexible Buttons
User Manual References
3.1.2 Settings on the Programming Mode
68 Feature Guide
DND Off