Panasonic KX-TDA100D Features Manual page 20

1.1.1 Incoming Trunk Call Features
Location
0001 123-4567
0002 123-2468
0003 123-456
:
® [451] DID Number
*1
® [452] DID Name
*2
® [453] DID Destination
*3
Note
Tenant number and VM trunk group number can also be assigned in the DID/DDI table. Tenant number is
used to determine the time mode (day/lunch/break/night) for the corresponding DID/DDI number. VM trunk
group number is used in Voice Mail DPT (Digital) Integration (® 1.24.3 Voice Mail DPT (Digital)
Integration).
Explanation:
If the DID/DDI number is "123-4567":
1.
Checks the number in the table.
® Matches the number in location 0001.
2.
Checks the time mode.
In Day mode: CLI is enabled. Route to CLI destination.
In Lunch mode: CLI is disabled. Route to DID/DDI destination, extension 100.
Conditions
•
To use this feature, DID/DDI service must be assigned as the distribution method for a trunk port.
•
DID/DDI Number Modification
It is possible to modify a received DID/DDI number, which may be convenient when programming the DID/
DDI table. The modification method (removed number of digits/added number) can be programmed on a
trunk port basis.
[Modification Example]
Removed number of digits: 6
Added number: 10
Received DID/DDI number: 87654321
•
Inter-digit Time
When the Inter-digit time expires, the PBX stops receiving the DID/DDI number and starts to check the
DID/DDI table. (Refer to the [Programming Example of DID/DDI Table] above).
Even if the Inter-digit time does not expire, the PBX stops receiving the DID/DDI number when the received
number is found in the DID/DDI table. The PBX then routes the call to the corresponding destination. If the
20 Feature Guide
No. Name
*1 *2
John
White
Tom
Smith
A
company
: :
CLI
Day Lunch
Enable Disable
Enable Disable
Enable Disable
: :
Modified DID/DDI number: 876543 21 = 1021
1) Remove the
first 6 digits.
Destination
... Day Lunch
... 105 100
... 102 100
... 101 101
: : :
2) Add "10".
*3
...
...
...
...
: