Alarm - Aquatronica evolution ACQ110 Instruction Manual

Level
Change Name
Programs
Unblock Program

Alarm

Measuring Unit
(Fig. 82)
Unblock Program
Enter: Confirm
Esc: Cancel
(Fig. 83)
Alarm
LEV 1: OFF
LEV 2: OFF
(Fig. 84)
54 - 60
Level Menu
To unblock the program, proceed as follows:
• When the error message appears (Fig.81) press the "Enter"
key.
• From the main screen press "Enter" and, using the keys
, select the "Level" menu.
• By using the keys  select "Unblock Program"
(Fig. 82) and press "Enter".
• The unblock program screen will appear (Fig. 83); press
"Enter" to unblock or "Esc" to cancel.
NOTE: the "Unblock Program" function temporarily
unblocks the program; therefore until the anomaly is re-
solved, the control unit will signal the error again after
a few seconds.
Alarm (Fig. 84)
In this menu it is possible to set a visual and acoustic alarm
that activates in the event that the level sensor assumes a
specific position.
It is possible to set the alarm, for example, to warn if the
water level exceeds a determined limit, or when the water
reserve is completely empty.
By setting the alarm "Without Sound" the level text on the
main screen will begin to flash the moment the level exceeds
the limits.
By setting the alarm "With Sound" the flashing text will also
be accompanied by an acoustic signal, and the icon
appear on the main screen.
Along with the flashing text on the main screen, the flashing
icon will indicate the activation of the alarm ( ).
To set the alarm, proceed as follows:
Main screen  Main Menu  Level  Alarm.
IsACQ110C-0 (ENG) Rev.230708-0
will